The crib is where your baby will spend a lot of
their time and you
want to be sure they are safe. Below are some of the questions (with
the answers) that are asked about crib safety. Topics such as mattress
position, how to place your baby in the crib, and general safety
standards are discussed, as are other issues. If you need further
information you can search the Internet and visit baby furniture
stores.
Q. Are there safety standards for baby cribs?
Yes there are some very exact standards for your
baby’s crib. In
1974 it was made law that cribs should no longer be painted with lead
based paint. It was discovered that the ingestion of lead (from any
source) could cause learning disabilities and other difficulties in
young children. The slats of the crib must be no more than 2 3/8 inches
apart, this is to prevent your baby from getting his body or head stuck
between the bars causing injury or strangulation. The side bar should
be 26 inches above the mattress when it is in its lowest position. If
your child is more than an inch taller than the sidebar it is time to
move him into a regular bed.
Q. Are there some hazards in my baby’s
crib that I need to be aware of?
Your mattress must fit snugly in the crib; an
ill-fitting
mattress could cause your baby to slip between the mattress and the
side bar causing suffocation. The mattress height should be able to be
adjusted into at least three different levels. When your baby becomes
more mobile you will want to put the mattress in the lowest position to
prevent your baby from climbing or falling out. The slats should be
tight, loose slats could pinch little fingers. Do not put the crib near
a window to prevent your baby from possibly falling out or becoming
tangled in Venetian blind cords.
Q. What are some historical facts about the crib?
Here is a short chronological time line of crib
facts:
1973 - The standard for crib slats was to be no
more than 2
3/8th inches apart to prevent your baby from slipping through or
getting their head stuck. Also, double latches for drop-down sidebars
were to become the norm.
1976 - The standard for cutouts in the crib end
panels are
presented. The end panels must not have any decorative cutout designs.
Children were getting their limbs or heads caught causing serious
injury or death.
1978 - Cribs must now be painted with non-toxic
finish.
1981 - Two models of cribs with cutouts are
recalled.
1988 - A voluntary standard addresses mattress
support hardware,
failure of glued or bolted connections, drop-side latch failure and
loosened teething rails.
1990 - No corner posts or projections can be more
than 1/16th of an inch above the drop-side.
1998 - California and Washington mandate that
hotel cribs must meet the same standards set for full-size cribs
1998 - Portable cribs must now meet the same
standards as full-sized cribs.
Q. How can I tell when my baby is ready for a
regular bed?
When your child stands more than a couple of
inches taller than
the sidebar with the mattress in the lowest position. If your child is
climbing out of the crib, for his safety put him in a regular bed.
Q. How should I put my baby to sleep in his crib?
Place your baby on his back or on his side for
sleeping. Use one
piece sleepers rather than blankets. Your baby could slip under the
blanket and possibly suffocate. Remove all pillows and toys as well, in
order to prevent suffocation.
Q. Is it safe to cover my baby with a blanket?
A blanket sleeper will keep your baby sufficiently
warm while
sleeping. If you absolutely need to use a blanket, tuck it in around
the bottom of the mattress. Place your baby with his feet toward the
end-panel and the blanket should go no higher than his/her chest.
Q. Is a mesh sided crib safe to use for my baby?
Yes, a mesh crib is safe provided the mesh is less
than 1/4 inch
in size, smaller than a tiny button on baby’s clothes. The
should be
rips, tears, or loose threads. If staples are used to attach the mesh
they must not be exposed and the mesh must be securely attached to the
top rail and the floor plate.
Q. Can I safely use bumper pads in my
baby’s crib?
While bumper pads are not necessary, they can
safely be used.
They must be very close the edge of the mattress and properly secured.
The bumpers must be flat and not puffy, as your baby could get stuck
between the bumper and the mattress and suffocate.
Q. What can I do to keep my baby’s crib
safe?
In order to keep your baby’s a safe
place, you should make sure
to all connections are secure and that there are no broken or missing
parts. Regularly, check the teething rail for splits or cracks. Make
sure the mattress spring support and your crib will withstand your
baby’s increasing mobility. The mattress itself should have
no splits,
tears, or holes.
Q. How can I tell when it’s time to
lower the mattress?
When your baby becomes more active, when s/he
begins to pull
himself to a standing position or when he sits up alone it will be time
to lower the mattress to prevent your little one from either climbing
out or falling out.
Q. Can I hang a mobile over my baby’s
crib?
Mobiles and crib gyms can be used to entertain
your baby but
when your child is able to get on to their hands and knees or pull
themselves up. This will prevent your baby from becoming entangled in
them.
In Conclusion
Making sure your baby’s crib is safe, is
an ongoing to task.
Proper positioning of the mattress, making sure all connections are
secure and that there are no loose slats that could pinch little
fingers will help to keep your baby’s crib a safe place for
him to be.
Be sure to place him in the crib on his back or side and dress him in a
sleeper rather than using a blanket. Keeping these tips in mind will
help keep your baby safe and give you some peace of mind.
About The Author
Martin Smith is a successful freelance writer
providing advice
for consumers on purchasing a variety of Nursery Bedding which includes
Baby strollers, Baby car seats, and more! His numerous articles provide
a wonderfully researched resource of interesting and relevant
information. For more information vist http://www.1st-babies.com